The Dini Group Introduces the DN7000k10PCI for ASIC Prototyping
The Dini Group Introduces the DN7000k10PCI for ASIC prototyping, IP
development and algorithmic acceleration. Here are >3.5 million ASIC gates on an
easy to use, PCI-hosted board. The DN7000k10PCI supports up to 3 of the largest
Altera Stratix II FPGA’s, the EP2S180. Each FPGA has it’s own 64-bit DDR2
SODIMM socket, which can be stuffed with 1 GB of DDR2 memory. The DINI
Group has alternate DDR2 compatible SODIMMs, which house SSRAM, QDR
SSRAM, FLASH, mictors, or RLDRAM. The industry’s highest performance PCI
controller, the QuickLogic QL5064, allows for high performance PCI mastermoding
without making any demands on the FPGAs. Configuration is handled via
PCI, Compact Flash, or USB.
ASIC and FPGA designers using the PCI Bus can prototype logic designs for a
fraction of the cost of existing solutions. “Here is the best solution for PCI ASIC
prototyping,” says Mike Dini president of The Dini Group. “ Developers of
complex, high speed ASICs will find this board to be the most cost effective way to
emulate their designs at anything like target frequencies.”
The DN7000k10PCI will be supplied with 1,2 or 3 FPGAs; prices start at only
$7,650. They are available directly from The Dini Group and their agents with leadtimes
of 2 weeks or less.
The Dini Group was established in 1995 as a consulting company. While
developing ASICs for various clients they saw the need for cost effective logic
emulation platforms and developed several of them. In 1998 they started selling
these platforms to ASIC developers and FPGA system users. From their offices in
La Jolla the dozen Dini Group employees have supplied over one billion ASIC
gates.
Agency Contact: Rob Britton, Electronics Marketing Group
619-231-6907
|
Be the first to review this article
